The True Blue kit's versatility bathtub highlighted by its ability to accommodate varying tub styles and thicknesses. Its unique overflow test plug serves dual purposes as a trim installation tool.

Additionally, the locking drain gasket ensures stability during challenging installations, while the pre-installed, reusable quarter-turn test plug adds to the ease of use. Its innovative overflow gasket is made from a specialized foamed rubber material, offering superior compression and memory than traditional counterparts. Uniquely, True Blue also allows for convenient trim change-outs, negating the need for a second rough-in kit purchase for future projects to refresh the look of your bathroom.

First, you'll need to uninstall the waste cover and the washer installed directly hookup the cover. You can do this using a screwdriver. Once you've removed these, make sure that the drain gasket is securely attached to the drain elbow, as this will be hookup for preventing leaks later on. After you've checked the drain gasket, take a moment to clean the area to ensure there's no debris that could interfere with your new installation.

Note: Before you begin, check the box to make sure you have all the pieces you need. It's also important not to reuse any of the old components. Firmly press the drain spud into the tub drain opening. From the bottom of the tub, hand tighten the drain elbow onto the spud. Make sure the elbow outlet is facing out and away from the tub once tightened. Ensure the blue overflow gasket is pre-assembled onto the overflow elbow. Insert the overflow elbow through the tub overflow opening. Once it's in place, hand tighten the overflow elbow with the threaded overflow lock nut.

In this step, you'll need to measure and cut the overflow and drain pipe to the desired length. Chamfer and deburr the cut ends. Dry fit the pipes to the elbows and sanitary tee to ensure proper fit. Apply an approved cleaner, primer, and cement, cuba online let it cure. Note: Primer should never be used on ABS components.

Finish tightening the drain spud drain overflow lock nut in place. Ensure drain test plus is pre-installed into the overflow elbow. Fill the tub above the overflow inlet and confirm that all connections are watertight. Once you've confirmed there are no leaks, remove all test plugs. Finally, install the overflow finish faceplate by turning it clockwise onto the overflow elbow until it locks into place.

Document Downloads (2)

Once the faceplate is secure, install the drain stopper onto the drain elbow, turning it until it's secure. If you are currently using Internet Explorer we recommend you switch to Edge or another supported browser to enjoy the best experience Oatey. Learn More.

Difficulty advanced. Time hours. Remove the Old Set Up First, you'll need to uninstall the waste cover and the washer hookup directly underneath the cover.

Insert the Drain Spud Note: Bathtub you begin, check the bathtub to make sure you have all the pieces you need. Insert and Tighten the Drain Elbow From the bottom of the tub, hand tighten the drain elbow onto the spud.

How to Remove and Install a Bathtub Drain

Insert the Overflow Elbow Ensure the blue overflow gasket is pre-assembled onto the overflow elbow. Connect the Pipes In this step, you'll need to measure and cut the overflow and drain pipe to the desired length.

Test for Leaks Finish tightening the drain spud and overflow lock nut in place. Install Drain Finish Faceplate Once you've confirmed there are no leaks, remove all test plugs. Related Resources. It appears that you're using an unsupported browser. Learn More OK.